Pre Flashed with Cromwell
bios Akira 1MB mod All Xbox
Version 1.0-1.5 compatible. Includes disable switch and wire header for
disable, wire for install or header for install. Installation
instructions
N/A
Pre Flashed with Cromwell
bios Ultimate CheapMod 2 Kit, includes disable switch and wire header for
disable, wire for install or header for install. Installation
instructions
N/A
CheapMod 2 All the
features of the original CheapMod but also offers write protect, and
disable header. (Requires programming and wire sold below for install)
N/A
Original CheapMod, these are
sold unassembled and are not programmed
N/A
Heatsink for
Xbox Nvidia Chip. Self adhesive thermal tape used to affix to the
board installation
N/A
24" 4
connector ATA 100 IDE cable. Perfect for dual hard drive mods.
You can only use 2 IDE drives at a time but this makes switching from one
to another much easier Installation
N/A
12V Case Fan Mod. Use
this power adapter to connect your existing case fan into the 12V
of the power supply. This increases the voltage supplied to the fan and
as a result, RPM and Cooling are enhanced.
N/A
Compatible with all Chips
sold at Llamma.com. Also compatible with 1MB modchips.
N/A
Blank
SST49LF020
N/A
De-Solder braid, a must for
quick cleanup. Works like a sponge to clean up excess solder.
Buy it here for less than you can find it locally!
N/A
DPST ON-ON toggle switch six
contacts two separate circuits. Use for disabling your
modchip. And lighting LED simultaneously to denote off/on status of
your mod.
N/A
30 gauge wire commonly
used for installing modchips and repairing traces.
$0.99 for 10X1 foot wires, one of each of the ten
available colors.
